Additional Functions; Minimum, Maximum, Average And Differential Measurement Function - VOLTCRAFT IR 1201-50D Notice D'emploi

c) Additional functions
The measuring device has various additional functions which can be used individually. Select and set these additional
functions with "F1", "F2" and "F3".
Press the "MODE" button to switch menu lines: The corresponding functions for the function buttons are displayed
individually depending on the menu.
The additional functions "MnMx", "Save", "Avg", "Mem" "E", "Hi" or "Lo" are not possible with contact
measurement. These functions pertain to IR measurements only.

Minimum, maximum, average and differential measurement function

The "Min", "Max", "AVG" and "Dif" measured values are saved during measurement (display shows
"SCAN") regardless of the currently displayed measuring function and are retained until the measuring
device switches off automatically. Set the automatic power-off time from 7 to 60 seconds for convenient
reading of measurement values.
During breaks in measurement, toggle between and read these values (display shows "HOLD"). During
measurement, it is not possible to toggle between the "MnMx" and "Avg" function. You can select a display
either before or after measurement.
Turn the measuring device on by briefly pressing the measuring button (5).
Select the desired display "MnMx/Avg" with "F1" or "F3" and conduct the measurement. After measuring, release the
measuring button.
Within the preset power-off time, enter the "MnMx/Save/Avg" setting mode with the "MODE" button.
Press "F1" to display the minimum and maximum values.
Press "F3" to display the average and difference values. The
average value "Avg" is calculated from the last measurement
period.
The difference value "Dif" shows the difference between the
minimum and maximum values.
Saving measured values "Save"
The "Save" function allows you to save up to 30 IR measure values in the internal memory. The stored data can be
read on the device via the "Mem" function or transferred to a computer via USB.
The storage of the measured data is only possible during breaks in measurement (display shows "HOLD"),
before the measuring device switches off automatically.
Set the automatic power-off time from 7 to 60 seconds for convenient storage of measurement values.
Turn the measuring device on by briefly pressing the measuring button (5) and conduct the measurement.
When the desired value is shown, release the measuring button.
Within the preset power-off time, enter the "MnMx/Save/Avg" setting mode with the "MODE" button.
Press "F2" to save the measured value.
40