Roco 10746 Mode D'emploi page 7

Only program on one of the programming tracks completely separated from the other hardware, in order
to avoid an inadvertant programming of other decoders. You will be able to program everything on the
hardware, up to the local addresses (CV1 or CV17+18), in the case of a digital control, such as the ROCO
multi MAUS, which has command of the 'POM' Mode.
Pay attention to the Tables in Fig 2 on page 17.
CV use
01 locomotive address
02 minimum speed
03 time of acceleration
04 time of braking
05 maximum speed
07 Version of the decoder
Manufacturer's identification or
08
return to default settings
Setting of speed steps, analogue
29
mode, driving direction: NMRA
49 load regulation
63 Dimmer for all function-outputs
8010746920 III_2009.indd 7
def.setting bandwith of possible changes
03 01 – 99
03 01 – 63
08 00 – 63
06 00 – 63
64 00 – 63
only reading!
151 only reading / reset to factory values = 08
Bit 0 driving direction: 0 = normal,
06
Bit 1 speed steps: 0 = 14, 1 = 28/128
Bit 2 analogue mode: 0 = aus, 1 = ein
01 01 = on / 00 = off
07 00 – 07
GB
1 = reversed
7
09.02.2009 07:26:32