Connections; Setup Information; Connections General - Philips CDR-795 Mode D'emploi

DIGITAL
OPTICAL
IN OUT IN OUT
1 2 3 4 5

Connections

1
OPTICAL IN
connect to the digital optical output of an external digital
appliance
2
OPTICAL OUT
connect to the digital optical input of an external digital
appliance
3
DIGITAL IN
connect to the digital coaxial output of an external digital
appliance
4
DIGITAL OUT
connect to the digital coaxial input of an external digital
appliance
5
ANALOG IN L/R
connect to the analog audio output of an external
appliance
6
ANALOG OUT L/R
connect to the analog audio input of an external appliance
7
AC MAINS ~
After all other connections have been made, connect
the power cord to the power outlet.

Setup information

Place the unit on a flat, hard and stable surface. Do not
position the unit on top of other equipment that might
heat it up (e.g. receiver or amplifier). If the unit is placed in a
cabinet, make sure to leave at least 3.5 cm (1.5 inches) free
around the unit to prevent overheating. Active mobile
phones near the unit may cause malfunctions.
ANALOG
L
R
IN OUT
6
7
~
AC MAINS

Connections general

Never make or change connections with the power
supply switched on.
For playback the following outputs are present:
– Analog output (ANALOG OUT L/R)
– Digital coaxial output (DIGITAL OUT)
– Digital optical output (OPTICAL OUT)
For external recording the following inputs are present:
– Analog input (ANALOG IN L/R)
– Digital coaxial input (DIGITAL IN)
– Digital optical input (OPTICAL IN)
These inputs can be connected to the corresponding
output(s) of your amplifier/receiver or directly to the
corresponding output(s) of the external appliance.
It is not possible to connect a turntable directly to
ANALOG IN L/R. If you wish to use a turntable with
the unit, you have to connect an amplifier/receiver to
ANALOG IN L/R on the CD player/recorder.Then
connect the turntable to the amplifier.
The connections you make will depend upon the
possibilities your audio equipment offers and how you are
going to use the unit. Please refer to the user manuals for
your audio equipment first.
We recommend doing analog recording only if digital
recording is not possible. Digital recording will result in
better sound quality.
If possible, always make both digital and analog connections.
In this way you can always make analog recordings when
digital recording is not possible.
Connections
9