SilverCrest SWKL 2200 A1 Mode D'emploi page 29

Heating the water to a specific temperature
The appliance has a setting allowing you to specify your desired water tempera-
ture. You can set a temperature of 70°C, 80°C, 90°C or 100°C.
♦ Before starting the heating process, press one of the temperature buttons
to choose the desired temperature. The pressed temperature button
light up blue.
♦ Afterwards, press the
temperature cannot be changed while the appliance is heating up.
♦ As soon as the water reaches the set temperature, you will hear a beep and
the appliance will switch to the keep-warm function. The temperature button
and
Keep-warm function
The keep-warm function allows you to keep heated water at a specific tempera-
ture for an extended period of time. As soon as the water temperature in the jug
sinks below the set temperature, the appliance will automatically heat it to that
temperature again.
The keep-warm function only activates if a temperature of 70°C, 80°C or 90°C
has been set. The
warm function remains active for 30 minutes. The appliance will then switch off
automatically.
NOTE
► If you remove the jug
is activated, the heating process will stop and the control lamp
blue.
► If you place the jug
warm function will remain active. The
ature selection button
► If you do not place the jug
appliance will switch off automatically. The control lamp
♦ Press the
Overheating protection
If the appliance overheats, the overheat protection automatically switches off the
heating element inside the appliance. The overheating protection is activated if
the appliance is switched on while the jug
If the heating element has been switched off by the overheating protection, allow
the appliance to cool down before using it.
■ 26
│ GB│IE
button
button will light up blue.
button will light up blue when activated. The keep-
from the base
back on the base
light up blue again.
back onto the base
button to turn off the keep-warm function manually.
to start the heating process. The set
while the keep-warm function
within 3 minutes, the keep-
button and the relevant temper-
within 3 minutes, the
contains no or not enough water.
SWKL 2200 A1
will
flashes
goes out.