Publicité
Les langues disponibles
Les langues disponibles
Switching the appliance on/off
The appliance will remain in standby mode for about 3 minutes if the mains plug
is plugged into a power socket. The appliance will then switch off automatically.
♦
Press the
lights and the control lamp
♦
Press the
mode.
Boiling water
♦
Lift the jug
♦
Open the lid
♦
Fill the jug
can spill out; however, do fill it at least up to the 0.7 L mark. When filling,
hold the jug
♦
Close the lid
♦
Place the filled jug
♦
Insert the plug into a mains power socket. You will hear a beep and all buttons
will light up blue briefly. Afterwards, the control lamp
button 100°C
♦
Press the
light up blue during the heating process.
♦
As soon as the water boils, you will hear a beep and the
WARNING – RISK OF INJURY!
►
Do not open the lid while the water is boiling or extremely hot. There is a
risk of scalding.
NOTE
►
You can stop the heating process at any time by pressing the
or removing the jug from the
►
If you remove the jug
heating process will stop and the control lamp
►
When you replace the jug
be continued until you press the
SWKL 2200 A1
button
for 2 seconds to switch the appliance off. The button
goes out.
button
again to switch the appliance back on in standby
off the base
to fill it with water.
by pressing the release button
no further than the MAX mark to ensure that no boiling water
upright. This allows you to read the scale
by pushing it down until it clicks into place.
onto the base
will light up blue.
button
to start the heating process. The
base
from the base
on the base
.
.
and temperature
.
during the heating process, the
flashes blue.
, the heating process will not
button
again.
GB│IE
correctly.
button
will
button
goes out.
button
25
■
│
Publicité
