EXIT Toys Trampoline Basketball Hoop Mode D'emploi page 7

8
Attach the U-pole (6) to the spring of basket (8) with an M6x50mm bolt (13) and an
M6 locknut (12). Note: Use this tool (14) to attach the M6X50mm bolt (13).
9
1. Remove a pole cap from the trampoline. Then loosen the bolt from fixed support
(7). Attach the fixed support (7) to upper tube and tighten four bolts of the fixed
support (7).
2. Hang the top fiberglass ring to the bracket of U-pole (6) as shown.
10
You can adjust the angle of the basketball board using the three M8 nuts as shown.
Congratulations! Your EXIT Trampoline Basket-
ball Hoop is now fully assembled (put together).
Trampoline
Basketball Hoop
7