Publicité
Les langues disponibles
Les langues disponibles
1
Insert the cable wire with a bushing (1) into the basketball board (3) in the direction
of the arrow.
2
1.
Insert the cable wire with a bushing (1) into the basketball board (3) in the di-
rection of the arrow.
2.
Then attach the cable wires with bushings (1) to each other.
3
1.
Insert the cable wire (2) into the basketball board (3) from the cut-out in the
direction of the arrow.
2.
Then insert the cable wire (2) into the bushing of the cable wire (1).
Note: to assemble this step, you need to have your feet planted on the other side of
the basketball board. This step must be assembled by an adult.
4
1.
Thread the cross cable wire (5) on the left side through the sleeve of the basket-
ball board (3). Attach the cross cable wire (5) to the U pole (6).
2.
Thread the cross cable wire (5) on the right side through the sleeve of the bas-
ketball board (3) from right to left in the direction of the arrow.
5
Insert the cable wire with plastic part (4) through the sleeve of the basketball board
(3). Attach the cable wire with plastic part (4) to the U-pole (6). Then attach the
plastic part of the cable wire (4) to the cable wire with bushing (1).
6
1.
First remove the pre-assembled M8 nut from the U-pole (6).
2.
Insert the adjusting bolt into the hole of the fixed support (7) and tighten the M8
nut.
3.
Attach the fixed support (7) to the U-pole (6) with an M8x55mm bolt (9) and an
M8 locknut (10).
7
Insert the spring of basket (8) into the hole of U-pole (6). Attach the basket (8) to
the U-pole (6) with an M6x65mm bolt (11) and an M6 locknut (12).
6
Use the accompanying assembly
drawings starting on page 29
Trampoline
Basketball Hoop
Publicité
