EINHELL GE-CM 36/37 Li Instructions D'origine page 30

11. Troubleshooting
Fault
The motor fails to
start
The motor perfor-
mance drops
Cutting is irregular
Motor stops sud-
denly
Anl_GE_CM_36_37_Li_SPK7.indb 30 Anl_GE_CM_36_37_Li_SPK7.indb 30
GB
Possible causes
a) Motor terminals disconnected
b) The mower is standing in high
grass
c) The mower housing is clogged
d) Safety switch is not inserted
e) Battery is not correctly inserted
a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
d) Battery performance decrea-
sing
a) The blade is worn
b) Wrong cutting height
a) Battery is overloaded
b) Battery is empty
- 30 -
Remedies
a) Have repaired by the Customer
Service Center
b) Start in low grass or on an area
that has already been mowed;
change the cutting height if neces-
sary
c) Clean the housing so that the bla-
de moves freely
d) Insert safety switch (see 6.)
e) Remove the battery and reinsert
(see 5.)
a) Correct the cutting height
b) Clean the housing
c) Replace the blade
d) Check the battery performance
and charge the battery if necessa-
ry (see 5.)
a) Replace or resharpen the blade
b) Correct the cutting height
a) Switch the equipment off and on
again. If this happens often, use a
battery with higher capacity (Ah)
b) Use a charged battery
26.04.2021 08:29:38 26.04.2021 08:29:38