Publicité
Les langues disponibles
Les langues disponibles
28
Warning:
You may not use track contacts that create connections to the track
voltage as these will destroy the LR101!
The terminals of several LR101 may not be connected to each other as
you are not dealing with continuous mass!
8.1 Experimental setup for the operation of the LR101
Figure 6
The display of the handheld (i.e LH100) will change depending on whether the
calliper is open or closed:
Calliper open
If you have set a delay for input 1, you will be able to monitor this delay on the
display of the LH100.
Installation, programming and wiring
can be easily tested:
Simply connect a calliper to signal
input 1, as shown in Figure 6. The
function 'Read out feedback' of the
handhelds LH100 or LH101 is well
suited for testing the correct wiring and
programming of the LR101. Status
changes of the calliper can be read
out
on
LH100/LH101. Our example assumes
that ex-works the LR101 is set to
address 65.
Change the mode of the handheld to
'Read
feedback address 65.
Calliper closed
Information LR101
the
display
out
feedback'
Calliper open again
of
the
and
select
Publicité
