Publicité
Les langues disponibles
Les langues disponibles
Proceed as follows:
5.
Make sure the Digital plus system is not put on 'Notaus' (emergency
shutdown) or 'Nothalt' (emergency stop).
6.
Carry out the steps required to switch a point (for detailed information on
how to switch points with Digital plus devices, please refer to the individual
operating manuals). For the point address, select the address to which you
want to set the LR101.
7.
Press the push button on the LR101 and keep it pressed until the LED
begins to shine.
8.
Proceed as if you wanted to switch the selected point and press the
corresponding key of the digital system. Here, it is irrelevant whether you
select 'branch' or 'straight'. The digital system sends a command containing
the point address. The LR101 (which is connected to the same line as the
switch decoders) receives this address and enters it into CV1 as its own
address.
The LED goes out as soon as this procedure is completed.
If you have chosen a value that exceeds the range permitted for the LR101, the
new address will not be entered. In this case, the LED will flash rapidly and then
go out.
Figure 3
25
E
Publicité
