Miele PWM 912 Mode D'emploi page 83

Safety clothing programmes
Helmets*
Fabric
Programme se-
quence
Extras
* The safety helmet manufacturer of must allow the helmet to be washed or dried by machine.
Before loading the machine, push the sliding visor, if applicable, into the safety helmet.
Place one helmet in each of the padded protective bags provided and close them.
The protective bags are available to order from the Miele Customer Service Department.
Remove easily removable attachments from the helmet and wash in a separate washing
net.
Gloves
Fabric
Programme se-
quence
Extras
After washing, air-dry the gloves with and without leather trim. Before drying, roll the
leather gloves or gloves with leather trim through your hands to maintain the elasticity of
the leather.
Belts*
Fabric
Programme se-
quence
Extras
* The belt manufacturer must allow the belt to be washed by machine.
If there are aluminium attachments on the belts, we recommend using a delicates detergent with reduced pH value which
is particularly effective for dissolving pigmentation stains.
60 °C (Cold to 60 °C)
Firefighter helmets
Pre-wash up to 40 °C
Main wash up to 60 °C, wash time 16 min
3 rinse cycles
Soak, Rinse plus
40 °C (Cold to 40 °C)
Gloves with and without leather trim
Main wash up to 40 °C, wash time 9 min
3 rinse cycles
Final spin
Leather care 40 °C
Final spin
Soak, Water plus, Rinse plus
40 °C (Cold to 40 °C)
Fire brigade belts also with aluminium compon-
ents and leather trim
Main wash up to 40 °C, wash time 8 min
3 rinse cycles
Final spin
Pre-wash, Rinse plus
en - Programme summary
Load ratio/ Load
size
PWM 912 – 3 hel-
PWM 916 – 4 hel-
PWM 920 – 5 hel-
Load ratio/ Load
size
Load ratio/ Load
size
mets
mets
mets
PWM 912 –
23 gloves
PWM 916 –
29 gloves
PWM 920 –
38 gloves
PWM 912 –
8 belts
PWM 916 –
12 belts
PWM 920 –
15 belts
83