Miele PWM 912 Mode D'emploi page 78

en - Programme summary
Cloths rtu
Fabric
Programme se-
quence
Extras
Cleaning cloths load size applies to the load ratio 1:18
Cleaning cloths
size/weight
PWM 912
PWM 916
PWM 920
The programme Standard cloths is also suitable for cleaning cloths that are not to be
used immediately after washing, but are to be stored after drying.
With the Cloths . . . + rtu programme, the cloths are ready to use and already impreg-
nated with cleaning agent or detergent and disinfectant. To achieve this, following wash-
ing or disinfection there is a finishing stage and then a final spin. The desired humidity
level of the cleaning cloths can vary by setting the residual moisture via the extra " –
" (moist, damp, wet, dripping wet). The dispensing quantities must be set on site and
the standard of disinfection must be checked.
The Cloths rtu programme is suitable for the subsequent finishing of clean and dry clean-
ing cloths. A disinfecting agent is applied during finishing. The dispensing quantities must
be set on site and the standard of disinfection must be checked.
78
Cotton, viscose, polyester and microfibre clean-
ing cloths
1 rinse cycle
then set the residual moisture via the extra " –
" (moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Add agent, Rinse hold
16 g/cloth
375
500
625
22 g/cloth
275
365
455
Load ratio/Load
size
1:18
PWM 912 – 6.0 kg
PWM 916 – 8.0 kg
PWM 920 – 10 kg
For number,
see
"Cleaning cloths
load size" chart
43 g/cloth
140
186
233