Cleaning And Storage; Descaling; Troubleshooting - MAXXMEE 6607.543.400 Mode D'emploi

EN

CLEANING AND STORAGE

Please Note!
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
• Regularly wipe down the housing with
a damp cloth and a little cleaning
agent if necessary. Then thoroughly
dry it.
• If necessary, brush fl uff and other
contamination off the brush
attachment (6). It can also be rinsed
with water. Then dry it thoroughly.
• Empty the water tank (7):
1. Remove the water tank (see the
"Filling the Water Tank" chapter).
2. Pull the water tank cap out of the
water tank, hold it over a sink or
similar outlet and turn it upside
down. Allow all the water to run
out of the water tank.
3. Reinsert the water tank.
4. Operate the device again for a
short time and press the steam
release button (3) to allow any
remaining amounts of water to
evaporate.
• Allow all parts to dry completely
before storing them away.
• Collapse the device by pulling the
handle release (2) downwards and
folding in the handle (Picture G).
• Place all parts in the storage bag
and store in a clean, dry place that is
protected from sunlight and is out of
the reach of children and animals.
16

DESCALING

Limescale deposits cause power losses
and shorten the lifespan of the device.
The thicker a limescale layer is, the more
diffi cult it is to remove.
We therefore recommend regularly
removing limescale deposits with a
descaling agent in accordance with the
water quality in your area and how often
the device is used (approx. every 4 – 6
weeks).
Use a standard descaling agent for
descaling. Make sure that it is suitable
for steam devices. Note the instructions
for use of the descaling agent for details
about the mixing ratio of water and
descaling agent and about the length of
use.

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an
electrical device yourself!
The device does not work, the
control lamp (5) does not light up.
The mains plug is not inserted in the plug
socket correctly.
► Correct the fit.
The plug socket is defective.
► Try another plug socket.
Water emerges from the steam
bottom (4).
The temperature has fallen below the
operating temperature.
► Wait until the control lamp is lit green
before pressing the steam release
button (3).