Cleaning And Storage - MAXXMEE YF-118-12 Mode D'emploi

EN

Cleaning and Storage

PLEASE NOTE!
■ Do not use any corrosive or abrasive cleaning agents to clean the device. These can
damage the surface. Do not use any metal objects to remove dirt from the steam
bottom.
1. Make sure that the device is switched off and the mains plug has been removed from
the plug socket.
2. Place the device down on a water-resistant and heat-resistant surface.
3. Allow the device to cool down completely.
4. Empty the water reservoir (13):
– Detach the water reservoir from the device by turning it anticlockwise so that the
arrow marked points towards the
– Pull the water reservoir cap (12) out of the water reservoir and hold the device over
a sink or similar outlet. Allow all of the water to run out of the water reservoir.
5. Insert the water reservoir again (see the "Use" chapter) and operate the device again
for a short time and press the steam release button (3) in order to allow any remaining
amounts of water to evaporate.
6. If necessary, brush fl uff and other contamination off the attachments. The attach-
ments can also be rinsed with water. Then dry them thoroughly.
7. If necessary, wipe down the outside of the device with a soft, slightly damp cloth and
then dry it with a soft cloth.
8. Store the device in a clean, dry place that is protected from sunlight and is not acces-
sible to children and animals.
Descaling
Descale the device regularly if distilled water is not being used to fi ll the water
reservoir.
Use a standard commercial descaling agent to descale the device. Make sure that the
descaling agent is suitable for steam devices. Note the instructions for use of the desca-
ling agent for details about the mixing ratio of water and descaling agent and about the
length of use.
22
position.