Attaching / Removing Attachments; Filling The Water Reservoir; Use - MAXXMEE YF-118-12 Mode D'emploi

Attaching / Removing Attachments

Filling the Water Reservoir

PLEASE NOTE!
■ Never pour any cleaning agent or other additives into the device. This may destroy
the device and safe working is no longer guaranteed.
■ Pour no more than 250 ml of water into the water reservoir (note the MAX marking).
The device can be operated with both tap water and distilled water. However, if
you use tap water, the device will need to be regularly descaled (see the "Cleaning
and Storage" chapter – "Descaling"). If you use distilled water, there is no need
to descale the device.
1. Fill the measuring cup (1) up to the MAX marking with water.
2. Pull the water reservoir cap (12) out of the water reservoir (13). Please note that it
cannot be completely detached from the device.
3. Carefully pour the water from the measuring cup into the water reservoir (note the
MAX marking).
4. Securely close the water reservoir cap again. Make sure that the water reservoir is
properly closed.

Use

PLEASE NOTE!
■ The device must be placed down on a stable surface. Do not turn the hot device up-
side down or place it on its side. Hot water could escape.
■ There must be plenty of space around the item of clothing which is to be smoothed.
You may only perform vertical smoothing if the item of clothing is hanging on a hanger
and cannot come into contact with other garments, objects, people or animals.
■ Before using the device, read the care instructions for the fabric which is to be
smoothed. Some fabrics, leather and suede as well as fabrics with fl ounces,
sequins and appliqués must not be steamed!
■ Always test the device fi rst on a small, inconspicuous spot on the clothing.
■ Do not iron over zips, studs, clips etc. to prevent any scratching of the steam bottom.
19
• Attaching: Place the attachment with the locking lug at the
top on the steam bottom and press it down fi rmly. The at-
tachment must be heard to engage in place.
• Removing: Pull the tab on the bottom of the attachment
forwards and remove the attachment.
CAUTION – Danger of scalding! Shortly after use,
the attachment used may still be very hot. Wait until
the device and the attachment used have cooled down
completely before removing them.
EN