Publicité
Les langues disponibles
Les langues disponibles
6. Remove the auger 5 from the screen as-
sembly 6 / sorbet assembly 19.
7. If necessary, remove the holder 7 from
the working container 8.
8. Turn the working container 8 anticlock-
wise until the
opened lock symbol
working container 8.
12. Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric
shock!
Pull the mains plug 11 out of the wall
socket before you disassemble and
clean the device.
WARNING! Risk of material damage!
Do not use any astringent or abrasive
cleaning agents.
After every use
• Clean the device and all accessories
used after each use and remove all food
residues.
• All accessories must be disassembled
and individually cleaned.
Seals
Proceed as follows for the hygienic cleaning
of the seals 20, 21 and 22:
• Figure A: remove the seal 20 from the
drip stopper 10.
• Figure B: take the seal 21 out of the
working container 8.
• Figure C: pull the seal 22 on the un-
derside of the working container 8 out
of the pulp outlet 17.
• The seal 22 remains firmly attached to
the working container 8 and can be
cleaned in the dishwasher or by hand.
• The seals 20 and 21 can be cleaned
either in the dishwasher cutlery basket
or manually.
mark points to the
. Remove the
• Allow the seals to dry completely before
reinstalling.
Base unit
DANGER! Risk of electric
shock!
The following parts must never be im-
mersed in water or other liquids, and
must not be cleaned in the dishwasher:
- the base unit 13 including the power
cable with mains plug 11.
The cleaning brush 14 must not be
cleaned in the dishwasher.
Wipe off the base unit 13 and the power
cable 11, using a lightly moistened cloth.
Dry with a dry cloth.
Accessories
The following accessories can be cleaned
both by hand and in the dishwasher:
-
Food pusher 1
-
Filling aid 2
-
Lid 4
-
Auger 5
-
Screen assembly 6
-
Holder 7
-
Working container (max. 300 ml) 8
-
Juice container (max. 600 ml) 15
-
Pulp container (max. 1200 ml) 16
-
Sorbet assembly 19
1. Remove food residues with the clean-
ing brush 14. Do not exert a lot of
pressure on the screen surfaces of the
screen assembly 6.
NOTE: chunky remains in the pulp outlet 17
can be easily removed using the rear side of
the cleaning brush 14.
39
GB
Publicité
