Panasonic AG-B23P Mode D'emploi page 6

Read this first! (For AG-B23E)
EMC NOTICE FOR THE PURCHASER/USER OF THE
APPARATUS
1. Applicable standards and operating environment
The apparatus is compliant with:
• standards EN55103-1 and EN55103-2, and
• electromagnetic environments E1, E2, E3 and E4
2. Pre-requisite conditions to achieving compliance with the above standards
<1> Peripheral equipment to be connected to the apparatus and special
connecting cables
• The purchaser/user is urged to use only equipment which has been
recommended by us as peripheral equipment to be connected to the
apparatus.
• The purchaser/user is urged to use only the connecting cables described
below.
<2> For the connecting cables, use shielded cables which suit the intended
purpose of the apparatus.
• Video signal connecting cables
Use double shielded coaxial cables, which are designed for 75-ohm type
high-frequency applications, for SDI (Serial Digital Interface).
Coaxial cables, which are designed for 75-ohm type high-frequency
applications, are recommended for analog video signals.
• Audio signal connecting cables
If your apparatus supports AES/EBU serial digital audio signals, use cables
designed for AES/EBU.
Use shielded cables, which provide quality performance for high-frequency
transmission applications, for analog audio signals.
• Other connecting cables
Use shielded cables, which provide quality performance for high-frequency
applications, such as connecting cables for IEEE1394 or USB.
• When connecting to the DVI signal terminal, use a cable with a ferrite core.
• If your apparatus is supplied with ferrite core(s), they must be attached on
cable(s) following instructions in this manual.
3. Performance level
The performance level of the apparatus is equivalent to or better than the
performance level required by these standards.
However, the apparatus may be adversely affected by interference if it is being
used in an EMC environment, such as an area where strong electromagnetic
fields are generated (by the presence of signal transmission towers, cellular
phones, etc.). In order to minimize the adverse effects of the interference on the
apparatus in cases like this, it is recommended that the following steps be taken
with the apparatus being affected and with its operating environment:
1. Place the apparatus at a distance from the source of the interference.
2. Change the direction of the apparatus.
3. Change the connection method used for the apparatus.
4. Connect the apparatus to another power outlet where the power is not
shared by any other appliances.
E-5
(continued)