Publicité
Les langues disponibles
Les langues disponibles
EN
3.
Press the U button on the remote control
again to continue lifting.
WARNING!
Do not stop lifting until the lifting frames
have passed the lower locking position.
4.
Release the U button to stop lifting
immediately after the lower locking
position, even if you are going to continue
lifting to the upper locking position.
5.
Check that the lifting blocks are located
at the vehicle's lifting points. If the lifting
blocks are correctly positioned, continue
lifting. If the lifting blocks are not correctly
positioned, press the D button on the
remote control to lower the vehicle. Make
the necessary adjustments.
6.
Check that the vehicle is correctly
balanced. If it is, continue lifting. If the
vehicle is not correctly balanced, press
the D button on the remote control to
lower the vehicle. Make the necessary
adjustments.
7.
Lift the vehicle a little way past the desired
locking position (lower or upper).
8.
Release the U button and press the D
button to lower the vehicle to the locking
position. The lowering of the lifting
frames is interrupted by locking.
9.
Check visually that both lifting frames have
been locked at the same locking position.
A. Lock bar
B. Turning block
C. Lock block
D. Locked position
FIG. 11
WARNING!
Before starting work on the vehicle or leaving
the area, check visually that both the lifting
frames are locked in the same locking position
and that all the lifting blocks are in contact
40
with the vehicle's lifting points. Work on the
vehicle can be performed when both the
lifting frames are locked in the same locking
position and all the lifting blocks are in
contact with the vehicle's lifting points. Never
work or spend time under a raised vehicle
that is not supported at the lifting points with
approved supports, such as jack stands.
LOWERING THE FRAMES FROM THE
LOCKING POSITION
WARNING!
When lowering Easy lift jack Frames, make
sure the Lock Bar and the Turning Block stay
in their tracks. If they get knocked sideways,
for example, they can get stuck on the rail of
the track, which could result in the Easy lift
jack not lowering correctly.
1.
Press and hold Up until the Lock Bar is
clear of the Lock Block.
2.
Lift the Lock Bar on both Easy lift jack
Frames so that the Turning Block is on top
of the Lock Block on both Frames, You
can use a tool to lift the Lock Bar.
BILD 12
3.
Press Down on the Remote control. Make
sure the Lock Bar clear the Lock Block on
both Easy lift jack Frames on their way
down. Release the Down button if either
side does not clear the Lock Block.
4.
Continue pressing Down until both Easy
lift jack Frames are lowered to the ground.
NOTE:
Easy lift jack recommends pressing Down for
a few seconds after the Frames are on the
ground; this ensures that as much Hydraulic
Fluid as possible returns to the Fluid
Reservoir.
5.
Remove the Easy lift jack Frames from
Publicité
