Hamron 009452 Mode D'emploi page 35

Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
Output
Lifting capacity
Min height*
Max lifting height**
Weight
Hydraulic fluid, volume
Hydraulic fluid, type
* The lifting frames cannot lift at minimum height
because they need space to build up hydraulic
pressure.
** With lifting block (434 mm without lifting block).
DESCRIPTION
1. Filler plug for hydraulic Fluid
2. Hydraulic fluid reservoir
3. Long hydraulic Hoses with couplers (X2)
4. Lifting frames (X2)
5. Safety Lock bar (X2)
6. Short hydraulic hoses with couplers (X2)
7. Rubber lifting blocks 55mm (X4) and
75mm(X4)
8. Remote control
9. Hydraulic power unit
10. Positioning handle
11. Seal Plug for hydraulic reservoir
FIG. 1
230 V ~ 50 Hz
750 W
2250 kg
75 mm
470 mm
97 kg
1.8 l
ISO 32 or ISO 46
ASSEMBLY
NOTE:
• On delivery there is no hydraulic fluid in
the hydraulic fluid reservoir on the
Hydraulic power unit. Fill with hydraulic
fluid before using the product.
• The short hydraulic hoses must be
routed under the bottom of the lifting
frames, never over the lifting frames.
1. Unscrew the filler plug (1) and fill with 1.8
litres of hydraulic fluid (ISO 32 or ISO 46)
in the hydraulic fluid reservoir (2). Screw
the plug on.
2. Connect the Female couplers on the long
hose (3) to the male couplers on the
hyraulic power unit (9).
FIG. 2
3. Routed the short hose (6) under the
bottom of the lifting frames(4), never
over the lifting frames.
FIG. 3
4. Connect the male couplers on the long
hoses to the female couplers on the short
hose.
FIG. 4
5. Connect the power unit to the power
supply.
6. The lift system is now ready to use.
FIG. 5
7. Press the U button (up) on the remote
control (8) to lfit and the D button (Down)
to lower.
FIG. 6
BLEEDING
Air may accumulate within the hydraulic
system after assemble the lift system, it cause
the jack frame to respond shake during the rise
or lower the lift, you can rise and lower the lift
EN
37