Publicité
Les langues disponibles
Les langues disponibles
EN
few time to bleeding the air from the system,
once the jack frame will not shake, you can use
the lift as normal.
USE
WARNING!
•
Read all the safety instructions and
other instructions.
•
Do not exceed the maximum permitted
load.
•
If the vehicle that is to be lifted is not
correctly positioned, there is a risk of it
falling, which could cause serious
personal injury and/or damage to
property.
•
Check the product for cracks in weld
joints as well as damaged, loose, worn
or missing parts each time before use.
Do not use the product before replacing
any worn or damaged parts.
IMPORTANT:
•
Do not raise the product to maximum
height without a load.
•
Each time before lifting, check that the
lifting frames are correctly positioned
under the vehicle and as parallel as
possible, that nobody is within the risk
area, that the lifting frames' Safety lock
bars are turned outwards and that there
are not obstacles around or above the
vehicle.
•
Familiarise yourself with the product
and its controls by raising and lowering
it a few times without a load. Do not
raise the product to the maximum
height without a load – only raise it to
the lower locking position. If the product
is raised to the maximum height without
a load, there is a risk of it becoming
stuck at maximum height.
38
•
Do not lower the vehicle if wheels or
tyres have been removed. There must be
space between the ground and the load
that is to be lifted, in order to raise the
lifting frames slightly before lifting the
load. The product cannot lift a full load
from a fully lowered position.
•
For optimum load stability, always place
the two lifting frames as parallel with
each other as the vehicle's lifting points
permit.
•
Never attempt to drive the vehicle up
onto the lift, as this will damage the
lifting frames.
•
Never lift a vehicle directly on the lifting
frames: always use lifting blocks.
•
Never leave the product unattended if it
is not fully lowered or locked in the
lower or upper locking position. Scissor
lifts are designed to only hold loads with
lock bar applied in the locking positions.
•
Only use lifting blocks of the same
height, do not mix low and high lifting
blocks.
LIFTING BLOCKS
A. Receiver tray, for the lifting blocks.
B. Safety Lock bar, must be on outside.
FIG. 7
LOCK POSITION
This lift system has Three locking positions:
A. Tracks.
B. Lower Locking Position.
C. The Turning Block MUST be remained in
the tracks.
D. Middle Locking Position.
E. Upper Locking Position.
FIG. 8
Publicité
