About Memory - A&D Medical LifeSource UA-789AC Guide D'instructions

About Memory

This monitor automatically stores up to sixty (60) blood pressure and pulse
measurements in memory. Measurements stored in memory are assigned
an index number in the order of the newest to the oldest.
To retrieve readings, follow these simple steps:
1. When the display screen is showing only the
time, press and quickly release the Memory
("M") button. You will see the date (month and
day) and time of the most recent blood pressure
that was taken followed by the measurement.
2. If you want to retrieve other measurements in
memory, press and release the Memory button
repeatedly until the desired date and time of the
measurement are reached. The measurement
will then be displayed.
3. The display will shut off automatically a few
seconds after the readings are displayed.
If there are no measurements stored in memory, you will see dashes in
the date and time fields followed by a measurement of three 0s displayed
vertically.
To clear the measurement history from memory, press and hold the
Memory button for at least five seconds while the display screen is
showing only the time. Release the Memory button when you see the M
symbol in upper left hand corner of the display flash and disappears. This
indicates that the memory has been cleared.
NOTE: Stored measurements, time, date, and alarm settings will be lost if batteries become low or are
removed for more than 30 seconds.
MONTH
DATE
TIME
E-13