DeWalt DXV06G Manuel D'instructions page 8

ENGLISH
3. Position the bag so that it is distributed around
the inside of the tank.
4. Replace and secure the power head onto
the tank.
Disposable
dust bag
WET PICK-UP
Remove all dirt and debris found in the tank. The
vacuum requires only a minimum of conversion when
going from dry to wet pick up. Remove the dust bag
from the vacuum. A clean cartridge lter may used for
vacuuming small amounts of liquids. For best results
when vacuuming large quantities of liquid, remove the
cartridge lter. When vacuuming liquids containing
debris, it is recommended to use a foam lter and
install over the lter cage. The foam lter may be
purchased by visiting our website at www.de-
walt.com, contacting our customer service depart-
ment, or purchasing at the local DEWALT distributor.
When picking up large amounts of liquid, it is
recommend to remove the cartridge lter. If the
cartridge lter is not removed, it will become
saturated and misting may appear in the exhaust.
At this time, you should dry or replace the cartridge
lter to eliminate the misting and possible dripping of
liquid around the lid.
WARNING:
1. Always shut off vacuum and disconnect the power
plug from the wall outlet before removing the power
head. Place power head in an upside down position.
Remove the cartridge lter by sliding it up and off the
lter cage.
2. Shake excess dust off the cartridge lter with a
rapid up and down movement.
NOTE: WET PICK-UP ACCESSORIES SHOULD
BE WASHED PERIODICALLY, ESPECIALLY
AFTER PICKING UP WET, STICKY FLUIDS
OR SPILLS. THIS CAN BE ACCOMPLISHED
WITH A WARM SOLUTION OF SOAP
AND WATER.
3. This wet/dry vac is equipped with a oat
mechanism which will rise automatically to
cut off the air ow when the liquid in the tank
reaches a predetermined level. When this
happens, turn off vac, unplug the power cord,
and empty the dust tank. You will know that
the oat has shut the air ow off because the
suction ceases and the motor noise becomes
higher in pitch due to increased motor speed.
The liquid capacity may vary with the
rate of pickup.
IMPORTANT: To reduce the risk of damage
to the vac, do not run motor with oat in
raised position.
Float in raised
position
NOTE: IF TIPPED OVER, THE VACUUM
COULD LOSE SUCTION. IF THIS OCCURS,
PLACE VAC IN UPRIGHT POSITION AND
TURN SWITCH OFF. THIS WILL ALLOW
THE FLOAT TO RETURN TO ITS NORMAL
POSITION, AND YOU WILL BE ABLE TO
CONTINUE OPERATION.
EMPTY THE TANK
WARNING:
To reduce the risk of injury from accidental
starting, unplug power cord before emptying
the dust tank.
1. Remove the power head assembly of the
wet/ dry vac by pulling outward on the lid
clips located on each side of the vac.
Lift off the power head assembly.
2. Dump the tank contents into the proper
waste disposal container.
6