DeWalt DXV06G Manuel D'instructions page 6

ENGLISH
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
UNPACKING & SETUP SUMMARY
1. Pull lid latches in an outward motion, remove
power head and some accessories that may
have been shipped in the tank.
2. Attach accessories following the instructions
in this manual.
3. Before replacing power head, refer to this
manual to ensure you have the proper lter
installed for the cleaning operation.
4. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in
place. Make sure all lid latches are
clamped securely.
5. Insert the hose end into inlet of tank.
6. Attach the extension wands to the end of the
hose. Apply slight pressure until tting is tight.
7. Attach one of the cleaning accessories
(depending on the cleaning requirements) to
the extension wands. Twist slightly to tighten
the connection.
8. Plug the cord into the wall outlet. The vacuum
is ready for use.
9. To reduce the risk of injury from accidental
starting, always shut off vacuum and
disconnect the power plug from the wall
outlet before installing any part or
cleaning accessory.
NOTICE:
See page 6 for wall mounting instructions.
WARNING:
To reduce the risk of re or explosion, do not
operate this vac in areas with ammable gases,
vapors or explosive dust in the air. Flammable
gases or vapors include but are not limited to:
lighter uid, solvent-type cleaners, oil-based
paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not
limited to: coal, magnesium, aluminum, and
grain or gun powder. Do not vacuum
explosive dust, ammable or combustible
liquids or hot ashes. Do not use this vac as
a sprayer for any ammable or combustible
liquid. To reduce the risk of health hazards
from vapors or dusts, do not vacuum
toxic materials.
WARNING:
The operation of any utility vac can result in
foreign objects being blown into the eyes,
which can result in severe eye injury. Always
wear safety goggles complying with ANSI
Z87.1 (or in Canada, CSA Z94.3) before
starting operation.
OPERATING INSTRUCTIONS
1. Plug the power cord into an appropriate outlet.
2. For remote control use, turn the switch on the
vacuum to the "
can be turned on or off by pressing the On/Off
button on the remote control at this time.
Besides, the vacuum also can be turned on by
turning the switch on the vacuum to the " I "
position and off by turning the switch on the
vacuum to the "O" position.
3. The DEWALT construction dust extractor is tted
with the DEWALT connection system. It allows
a fast, secure connection between the suction
hose and power tool. The connector connects
directly to DEWALT compatible tools or through
the use of an adapter (available from your local
DEWALT supplier). Refer to the accessories
section for detail on available adapters.
O= OFF I= ON
RESETTING THE REMOTE CONTROL
1. Plug the power cord into an appropriate outlet.
2. Set the power switch on the vacuum to the
remote control option"
3. Put the remote control close to the vacuum
cleaner rst (less than 0.5m [18 inches]). Press
and hold the pairing button
control for about 3 seconds. The LED Indicator
will ash and the vacuum will make a sound
(about 0.5 seconds) which is caused by the
motor rotation to indicate that the pairing was
successful. After that, the vacuum cleaner can
be controlled by the remote control.
TO UNPAIR WITH THE REMOTE CONTROL
1. Plug the power cord into an appropriate outlet.
2. Set the power switch on the vacuum to the
remote control option"
4
" position, and the vacuum
LED Indicator
On/Off Button
Pairing Button
= Remote Control
".
on the remote
".