Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Manual de usuario
PARAMETERS TABLE
FUNCTION
F1 UNT
F2 EL
F3 PRT
TECH
P1 LIN
P2 CAL
P5 GRA
32
Sets the which units want to use: g / ct / lb / oz / d / gn / ozt / dwt / mm / tl.T / tl.c / tl.t / t use
switch, use
key to sure.
Set the backlight to be on, automatic or off.
EL on: Backlight always on
EL Au: Backlight automatically turn on
EL off: Backlight allways off
Use
to switch, use
P cont, continuous sending.
P auto, when the weight is stable sends the data.
P prt, printer. Press
9600 bps), press
to change speed and
printer (LP-50 or TP), press
Pin
Enter the programming and calibration menus by entering the correct password (
and press
key to enter.
Linear calibration.
Press
. Display will show PIN again. Press keys
Display will show UNLOAD. Take off all the weight of the tray. Display will show the !rst request of
weight for the calibration. Place this weight on the tray, when the balance is stable ignites the stability
indicator and accepts this weight automatically.
After the !rst calibration of weight, display will show the following calibration weight. Place this weight
on the tray, when the balance is stable ignites the stability indicator and accepts this weight automa-
tically.
After the second calibration of weight, display will show the following calibration weight. Place this
weight on the tray, when the balance is stable ignites the stability indicator and accepts this weight
automatically.
The scale will begin to count backwards until reaching zero after it has accepted the last weight. During
the count down, you must retire all the weight of the platform.
The scale becames in normal weighing mode.
After entering in the calibration mode, display will show UNLOAD. Take off all the weight of the tray.
When the scale is stable, it will !x initial zero point automatically. Then display will show LOAD. Place
the weight for the calibration on the scale.
Minimum calibration weights:
BAT300, 50g.
BAT600, 100g.
BAT1500, 300 g.
BAT3000, 500 g.
Place this weight on the tray, when the balance is stable ignites the stability indicator and accepts this
weight automatically.
The scale will begin to count backwards until reaching zero after it has accepted the weight. During the
count down, you must retire all the weight of the platform.
The scale becames in normal weighing mode.
Gravity.
It appears the value of gravity, to change this value use the keys:
, places the value to 0.
, increases the value of the active digit.
, changes the active digit at right.
, changes the active digit at left.
Press
to save.
DESCRIPTION
key to sure.
, now you can select the speed of transmission (600, 1200, 2400, 4800 or
to change printer and
Laboratory scale
to save the wished speed. Now it selects the
to save.
,
,
y
Modelo BAT
to
)
to enter.
Publicité
Table des Matières
