Publicité
ENGLISH
When used horizontally, the loudspeakers of the DVX P series allow to maintain the same
coverage angle through a rotating horn.
If you wish to change the coverage angle:
- undo the fixing screws of the grille
- remove the front protective grille by slightly pressing on one side and taking the grille off the
special slots
- undo the eight fixing screws of the horn
- rotate the horn in the desired position (the horn should never be removed from the loudspeaker)
- tighten the fixing screws of the horn
- put the grille back in the special side slots and tighten the screws of the grille.
LOUDSPEAKER INSTALLATION
WARNING
Make sure that the loudspeaker is securely installed in a stable position to avoid any
injuries or damages to persons or property.
For safety reasons do not place one loudspeaker on top of another without proper
fastening systems. Before hanging the loudspeaker check all the components for
damages, deformations, missing or damaged parts that may compromise safety during
installation.
If you use the loudspeakers outdoors avoid places that are exposed to bad weather.
The loudspeaker has the following mounting options:
-
bookshelf
-
floor (monitor)
-
standmount
-
suspended with support rails or brackets supplied by the manufacturer
WARNING
Never use the handles to hang the speaker!
Use the handles only to move the single
speaker!
WARNING
To hang the loudspeaker use only one screw for each hanging point
The hanging points are M8 for DVX P8 and DVX P10, or M10 for DVX P12
and DVX P15
NO!
TECHNICAL SPECIFICATION
11
YES!
DVX P series – passive speaker
YES!
Publicité
