Publicité
Les langues disponibles
Les langues disponibles
Kb
Fig. 2
Spread a thin layer of glue in the dowel holes in the Left and Right Sides (Kb and Lb) and insert
2.
six Dowels (Y). Insert the Dowels (Y) in the Left Side (Kb) into the holes in the Sleepers (M). Face
the notches in the two lower sleepers toward the bottom and face the notches in upper sleeper
to the inside. The edges of the sleepers should be flush with the edges of the sides.
Glue the Right Side (Lb) to the Sleepers (M). Insert #8 x 1-3/4" Pan Head Screws (S) into the
predrilled holes in the notches in the sleepers and fasten securely. See Figure 2.
Attach the Base (O) to the lower front Sleeper (M) by inserting three #8 x 1-1/4" Black Screws (T)
through the holes in the sleeper into the back of the base and tighten securely. The bottom of the
base must be flush with the bottom of the sides. See Figure 2.
Place a 90° Angle Bracket (ZA) on the Base (O) and each Side (Kb & Lb) approximately one inch
from the bottom of the unit and flush with the front edge of the sides. Attach using #6 x 5/8" Undercut
(Type17) Screws (U). See Figure 2.
Fig. 3
Slide the Top (N) down so that the four Cam Connectors (Q) fit into the four holes in the top of the
3.
Sides. Insert the Cam Housings (R) and tighten securely. Insert three #8 x 1-1/4" Black Screws (T)
through the holes in the sleeper into the top and fasten securely. See Figure 3.
Y
M
Y
U
ZA
Q
T
S
M
T
T
M
S
S
R
T
T
Lb
Y
Y
U
ZA
O
N
Q
Page 5 — 582Wd — 03/14
Publicité
