Publicité
Les langues disponibles
Les langues disponibles
Cam-Lock System
NOTE: To avoid scratching the surface of the
wood, assemble the unit and place face-down
on a clean, protected surface.
DO NOT embed
the shoulder into the wood!
1.
Insert the Cam Housing so the arrow faces the Cam
Connector. To achieve tension and holding power, you MUST
TURN the Cam Housing clockwise at LEAST 1/4 turn to the
9:00 position. Turning the Cam Housing between 1/4 and 1/2
turn should be enough to ensure rigid tension. Tension
should be initiated as soon as 10:00. You should receive
optimum tightness at 11:00. IF this does not occur, tighten or
loosen the Cam Connector to achieve proper tension.
2.
You may need extra tension if:
A. The Cam Connector was screwed in deeper or not as deep
as if should.
B. If the furniture is repeatedly assembled and disassembled.
C. If you place a heavy load in the unit.
To achieve extra tension, tighten the Cam Connector
between the 11:00 and 12:00 positions.
INSTRUCTIONS
Cam Connector
Shoulder must be
flush with the surface
of the wood.
Wood
Optimum
tightness
11
10
9
8
7
Correct way to tighten
your Cam-Lock system.
Shelf
Install the Cam
Housing so the
arrow is directly
over the bolt.
Cam
Housing
Lock the Cam
Housing with:
Phillips
Screwdriver
Slotted
Screwdriver
Face of
Cam Housing
12
1
2
3
4
5
6
Side Panel
Cam Connector
Cam-Lock – Rev. 01/09
Publicité
