Télécharger Imprimer la page

HP CM8060 Guide D'installation page 245

Masquer les pouces Voir aussi pour CM8060:

Publicité

fournisseur. Toute réparation ou modification effectuée par l'utilisateur ou tout dysfonctionnement de
l'équipement peut conduire l'opérateur téléphonique à demander le retrait de cet équipement. Pour sa
propre protection, l'utilisateur doit s'assurer que les prises de terre du circuit électrique, les lignes
téléphoniques et le système interne de conduites d'eau métalliques, le cas échéant, sont interconnectés.
Cette précaution est particulièrement importante en milieu rural.
ATTENTION :
doivent contacter l'autorité compétente en matière d'installation électrique ou un électricien qualifié,
selon le cas. L'indice d'équivalence de la sonnerie (IES) de ce périphérique est 0,7.
Remarque : l'IES affecté à chaque terminal donne une indication du nombre maximum de terminaux
qu'il est possible de brancher sur une même prise téléphonique. Le raccordement sur la prise peut
inclure n'importe quelle combinaison de périphériques, à condition que la somme de l'IES de tous les
périphériques n'excède pas 5. La connexion (type de prise téléphonique) standard pour les équipements
qui se connectent directement au réseau téléphonique est CA11A.
Telecom statement for New Zealand
General conditions
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted
that the item complies with minimum conditions for connection to its network. It indicates no endorsement
of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance
that any item will work correctly in all respects with another item of Telepermitted equipment of a different
make or model, nor does it imply that any product is compatible with all of Telecom's network services.
Some parameters required for compliance with Telecom's Telepermit requirements are dependent on
the equipment (PC) associated with this modem. The associated equipment shall be set to operate
within the following limits for compliance with Telecom's Specification:
For automatically initiated calls to the same number
(a) There shall be no more than 10 call attempts to the same number within any 30 minute period for a
single manual call initiation, and the equipment shall go on-hook for a period of not less than 30 seconds
between the end of one attempt and the beginning of the next attempt.
For automatically initiated calls to the different numbers
The equipment shall go on-hook for a period of not less than 5 seconds between the end of one attempt
and the beginning of the next attempt.
Auto-answering incoming calls
Incoming calls shall be answered between 3 and 30 seconds of receipt of ringing.
For correct operation of the ringers in each device, the total of the RN's of all devices connected to a
single line at any time should not exceed 5. The RN (Ringer Number) can be found printed on the
Telepermit Label.
Telecom statement for Australia
In Australia, the fax modem must be connected to the Telecommunication Network through a line cord
which meets the requirements of the Technical Standard AS/ACIF S008.
FRWW
Les utilisateurs ne doivent pas essayer de réaliser ces connexions eux-mêmes. Ils
Déclarations sur les télécommunications 231

Publicité

loading

Ce manuel est également adapté pour:

Cm8050