Fault Messages; Safety Cut-Off - infra world Saunacontrol T3 Notice De Montage Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Press the
button in standby mode and the start screen will appear.
Hold the
button for longer (2 sec.), the display shows "prog. pre-select OFF" (see item 8).
Press the
button once. The display shows "max. operat time".
The operating time can be adjusted with the
Max. 6 hours in private operation, max. 12 hours in commercial operation (STANDARD EN60335-2).
prog. pre-select
max. operat time
By pressing the
"-pre-select active-" will appear).
In the case of sensor interruption, low water level and cover protection system response, the heating is switched
off immediately. The display shows the fault in the bottom display line.
sauna
temperature:
temp.-sensor
EN
If the cable connected to the operating or sensor unit is interrupted, the heating circuit is cut off immediately. In
addition to this, the cabin is provided with a safety temperature limit controller.
If the maximum temperature of 128 °C is exceeded, it means there is a defect and the sauna is switched off. In
this case, an expert must be consulted.
When the heater cover protection (rocker) is activated, the heating circuit is cut off immediately and the display
shows an error message.
When the low water level sensor has responded, the evaporator is switched off and on within a three second cycle
(audible alarm with heaters having an integrated buzzer). Please take into account the instructions for use!
34
9. MAXIMUM OPERATING TIME
OFF
02:00:00
button again, the controls change to the start screen (if "prog. pre-select = ON" is selected,

10. FAULT MESSAGES

01:25:30
Possible fault messages:
temp.-sensor ...
- - °C
safety sensor ...
humidity sensor ...
infrared sensor ...
! Low water level ! ...
! cover protection ! ...

11. SAFETY CUT-OFF

or
button from 30 minutes to 20 hours in 10-minute steps.
interruption of the room temperature sensor
interruption of the safety limiter
interruption of the humidity sensor
interruption of the panel sensor
low water level sensor in the heater has responded
heater cover protection system has been activated

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

B6755

Table des Matières