Displaying Operating Statistics; Changing The Operating Values - infra world Saunacontrol T3 Notice De Montage Et D'utilisation

6.6.

Displaying operating statistics

Operating statistics are shown by holding down the
(when the sauna is off, standby).
operating hours
sauna 102:12
evaporator 102:12
infrared 018:00
Operating mode
Exit by pressing the
To change the basic setting, the sauna must be activated in the respective operating mode (sauna, evaporator,
surface heating, radiator).
-settings-
temperature:
relative hum:
temperature IR:
You can select the different temperatures or the rel. hum. by pressing the
After a button hasn't been pressed for 5 seconds, the set value is stored (counter on the top right hand side of
the display) and the sauna changes to normal operation.
7.1. Setting the sauna operating mode
The sauna operating mode is enabled in the cabin (see item 6.2).
1 x
EN
temperature:
Adjust the temperature via the plus or minus button as desired. Temperatures are adjusted in one-degree steps
between 30 and 110 °C.
2 x (
blower
Use the button to switch the blower on and the
30
Total operating hours
218:48
(hours, minutes)
218:48
187:02
021:09
Heating time Operating hours
button

7. CHANGING THE OPERATING VALUES

4
Counter
50
°C
49
%
60
°C
100
°C
only with ventilator function = YES)
ON
button and by briefly pressing the
button.
button to switch it off.
button