infra world Saunacontrol T3 Notice De Montage Et D'utilisation page 23

4.1. Power unit:
The power unit is placed on the roof of the sauna cabin and fixed with two screws.
4.2. Mounting the operating unit to hang onto outer wall:
I. Drill a hole with a diameter of 20 mm at the position of the cable duct, at a height
of approx. 1500 - 1700 mm (Fig. 1).
II. From the drilled hole measure 65 mm to the top, then 40 mm to the left. This is the position of the left
mounting screw (Fig. 2).
III. Fix the right mounting screw at a horizontal distance of 110 mm (Fig. 2).
IV. Next, use a pulling aid to lead the black connecting cable through the drilled hole onto the roof and
connect it to the power unit.
V. Finally, hook the operating unit onto the fixed screws (Fig. 3).
Fig. 1
4.3a. Mounting the retractable operating unit to the outer wall:
I. Make a recess (W x H: 100 x 110 mm) at approx. 1500 – 1700 mm height at the intended position on
the outer wall of your cabin (Fig. 4).
II. Put the operating unit into the plastic frame supplied (Fig. 5).
III. By using a pulling aid, lead the black connecting cable of the operating unit through the cable duct of
the sauna onto the roof (Fig. 8).
IV. Hook the operating unit onto the bottom of the recess on the sauna wall and fix it to the top using the
metal clamps on the back (Fig. 6).
Fig. 4
4. ASSEMBLY
Fig. 2
Fig. 5
Fig. 3
Fig. 6
EN
23