Worx D-LITE WX100 Mode D'emploi page 19

Verify the torque position of the torque adjusting ring.
Find the torque adjusting ring between the chuck and the
drill body. Position 1 is the lowest torque (screw driving
force) and position 20 is the highest torque (screw driving
force). Position is for drill operation. Regulate the torque
adjusting ring to a higher position to reach the best result.
(3) I CAN NOT FIT THE BATTERY PACK INTO THE
BATTERY CHARGER. WHY?
The battery pack can be inserted into the charger only in
one direction. Turn the battery pack around until it can be
inserted into the slot. The charger LED indicator should
turn on when the battery pack is charging.
(4) REASONS FOR DIFFERENT BATTERY PACK WORKING
TIMES
Charging time problems, as above, and having not used a
battery pack for a prolonged time will reduce the battery
pack working time. This can be corrected after several
charge and discharge operations by charging & working
with your drill. Heavy working conditions such as large
screws into hard wood will use up the battery pack energy
faster than lighter working conditions. Do not re-charge
your battery pack below 0 C and above 45
o
affect performance.
7.MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
FOR BATTERY TOOLS
The ambient temperature range for tool and battery use
and storage is 0℃-45℃.
The recommended ambient temperature range for the
charging system during charging is 0℃-40℃.
8.ENVIRONMENTAL PROTECTION
retailer for recycling advice.
9.DECLARATION OF CONFORMITY
We,
Positec Germany GmbH
C as this will
o
Postfach 32 02 16, 50796 Cologne, Germany
Declare that the product
Description Worx Drill Driver
Type
designation of machinery, representative of Battery-
powered Drill)
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
WX100 WX100.X WX108 WX108.X(1-
WX370 WX370.X(3- designation of machinery,
EN
19