Worx D-LITE WX100 Mode D'emploi page 121

CHUCK JUSTERING
C
ADVARSEL: Når du bytter tilbehør, må du alltid
låse avbryteren og koble verktøyet fra
strømkilden. Forsikre deg om at boret er sikkert før du
starter verktøyet. Skader eller løshet på chucken kan
føre til personskade.
-- Fjerning av bitene
-- Innsetting av bitene
-- Montering av beltekrok
OPERATION
FORWARD/REVERSE ROTATION
CONTROL
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it has stopped!
TWO-SPEED GEAR CONTROL
TORQUE ADJUSTMENT
SCREWDRIVING, DRILLING, HAMMER
DRILLING
OPERATING THE ON/OFF SWITCH
WARNING: Do not operate
for long periods at low speed
because excess heat will be produced
internally.
LED LIGHT INDICATOR (Se figur. G)
To turn on the light, press the on/off switch and make sure
Se figur B1
the forward/reverse rotation control is on right/left position.
When you release the on/off switch, the light will be off.
Se figur B2
LED lighting increases visibility-great for dark or enclosed
area. LED is also a battery capacity indicator. It will flash when
Se figur
power gets low.
C1, C2
The tool and battery pack are equipped with a protection
system. When the LED Light is quickly flashing and turn off,
the system will automatically cut off power to the tool to
extend battery life. The tool will automatically stop during
operation if the tool and/or battery pack are placed under
Se figur
.D1,
one of the following conditions:
D2,D3
• Overloaded: The tool is operated in a manner that
causes it to draw an abnormally high current. In this
situation, release the Trigger Switch on the tool and stop the
Se figur
. E application that caused the tool to become overloaded. Then
pull the Trigger Switch again to restart.
• Overheated: Under the condition above, if the tool does
Se figur
.F1,
not start, the Tool and Battery Pack are overheated. In this
F2, F3
situation, let the Tool and Battery Pack cool before pulling the
Trigger Switch again.
• Low battery voltage: The remaining Battery capacity is
too low and the tool will not operate. In this situation, remove
Se figur
. G
NOR
121