Drain Cleaning - Wohler Rm 400 Instructions De Service

Operation
5.3

Drain Cleaning

Fig. 7: Drain cleaning
Setting options / settings
32
WARNING!
Protective equipment:
Guide the cable only with a suitable protective
glove.
Wear protective glasses depending on the appli-
cation.
Wear safety shoes with rubber soles (insulation)
during cleaning work.
• Loosen the black lock knob.
• Select an appropriate auger and securely
connect it to the cable.
• Position the machine close in front of the
opening of the pipeline you wish to clean. En-
sure a firm stand.
Push the cable through the outlet nozzle into
•
the drain entrance.
Then tighten the lock knob a little so that the
•
cable can be operated
NOTE!
If the lock knob is tightened too much, the cable
will block in the machine. If it is tightened too little,
no back and forth movement is possible.
• Connect the Wöhler RM 400 to the mains and
perform the test with the PRCD-switch accord-
ing to chapter 6.1.1.
The automatic feed can be adjusted via con-
•
trol switch and handle.
ATTENTION!
Never pull or push the cable while the auto-feed is
active.
• Proceed as follows:
Switch FOR + handle up
•
Cable turns to the right and is pushed out.
freely..