Connection To Other Equipment; Connecting To Other Equipment - JVC LT-19HA22U Mode D'emploi

Connection to other equipment

1. Connecting to other equipment

Attention: Preparation:
• Disconnect all equipment from the AC-supply, to prevent any possible damage.
• Make the necessary connections.
• Make sure all connections are safe & secure before reconnecting your equipment the AC-supply.
Please connect your satellite-receiver or DVD player via SCART (AV1). Make sure your SCART cable's cross-
section is at least 1 cm or more. SCART cables with less thickness may cause visible noise.
Please make the following settings inside your receiver's / DVD-player's setup-menu:
Video signal: RGB
TV-Format: 16:9
If you miss to make these settings properly, picture quality will be inferior and parts of the picture
might be missing. This is not a fault of this TV-set.
In case you need help to make this adjustment with your satellite-receiver / DVD-player, please consult
the related instructions or contact the supplier or maker of those apparatus for support.
Please use the satellite's remote-control handset to select Teletext or desired TV-station. Generally it is
not possible to store satellite TV-stations into a standard TV.
If the TV does not automatically switch to AV-1, please select INPUT AV1 manually, as seen on page
12.
Satellite antenna
2. Connect video recorder (e.g. to record from DVB-T)
LT-19.../LT-22....
TV (Rear view)
(All illustrated SCART cables are not supplied)
LT-26.../LT-32....
TV (Side view)
(All illustrated SCART cables are not supplied)
24
Satellite
receiver
VCR TV
Video recorder to AV1
Video recorder to AV1
Video recorder
(All illustrated SCART cables and
antenna cables are not supplied)
Note:
• Programme the video recorder timer
to the desired time. The TV appliance
cannot switch the video recorder on
or off.
TV