Selecting The Input Source; On-Screen Language Selection; Station Search; Changing The Order Of Stored Channels - JVC LT-19HA22U Mode D'emploi

Selecting the input source

Press INPUT SELECT to view a signal from
another device connected to your TV, such as a
VCR or DVD player. You can select each input
source depending on which input jacks you used to
connect your devices.
To select the video input source, press INPUT
SELECT or / .
Then press ENTER within 6 seconds.

On-screen Language Selection

1
Select (unless you have already selected
when the set was first switched on) then press
.
Picture
Audio
Setup
Option
Lock
2
Press or
3
Press MENU to exit the menu.

Station search

Warning! All previously saved channels are
deleted in Step 2. A new channel search then
starts automatically.
Preparation:
Make sure your antenna is connected to the antenna input
(see P.10). Select TV (see above). Then press MENU.
1
Select Channel Set Up option in
press .
2
Select Auto Scan, then press .
3
TV will search for Digital TV-channels at first.
Continue with ENTER to start auto tuning.
Note:
• Press RETURN if you return to step 2.
4
The automatic scanning will search for
available Digital TV-channels and should store
the channels in the correct order.
12
to select the desired language.
5
When all DVB-T programs have been stored
(100%), you will be asked if you want to
proceed to autotuning Analog TV-channels.
If you wish to start the tuning Analog cable-
TV channels. connect your Analog cable-TV
antenna and press ENTER.
Note:
• Press RETURN x 2 if you return to step 2.
6
When all programs have been stored (100%),
press MENU to exit the menu.

Changing the order of stored channels

The Automatic station presetting stores the
stations in a specific order. However, this order
can be changed if you wish.
1
Press MENU. Select Channel Set Up option in
2
Select desired option, then press .
Description about the each setting option:
Channel Skip: Press
want to skip, then press ENTER.
Channel Sort: Press
want to move, then press ENTER.
Press or
the channel to, then press ENTER.
Channel Edit: Press
want to edit, then press ENTER.
Following options are displayed.
, then
- Channel Number: Press 0-9 buttons to enter
the desired memory position number, then press
ENTER.
- Frequency (only for analogue TV): You can also
directly enter the frequency value with Number
buttons (0-9), then press ENTER.
- Colour system (only for analogue TV): Colour
System has already been preset to Auto.
Do not change anything here. Any changes can
cause picture or sound disruption.
- Sound system (only for analogue TV): The
correct sound system is already installed. Any
changes can cause sound disruption.
Fine (only for analogue TV): Already correctly and
optimally installed. Do not change anything here. Any
changes can cause picture or sound disruption. The video
can also be affected.
Signal Status (only for digital TV):You can verify the
signal strength and quality of the selected service here. If
necessary, adjust the direction of the antenna to obtain the
maximum signal strength.
3
Press MENU to exit the menu.

Update Scan

If you wish to search and store only new channel,
perform the Update Scan at step 2 of Station
search (on the left). The current channel store is
remained and only new channel will be stored to
channel store.
TV will search for Analogue CH,
please connect aerial(RF) lead.
Then press "ENTER".
100%
, then press .
or to select the channel that you
or to select the channel that you
to select the position that you want to move
or to select the channel that you
mark will appear.