IXIT REVERSE SENSOPLATE Manuel D'installation & D'utilisation page 22

A firewall is provided, want to install it
in the hole of passage of the cable as
the diagram indicates it opposite.
P r e s s t o t h e m a x i m u m
SENSOPLATE against the car body in
order to ensure the best possible
sealing.
• STICKING THE SENSOPLATE
Please clean the part where to stick the SENSOPLATE in an extremely rigorous way. Use a product
cleaning grease-remover and not to leave any trace of dust or moisture on this part.
2 types of stickers double-faced cloth are provided:
• 8 stickers thickness: 0,8 mm.
• 8 stickers thickness: 3 mm.
The part of body on which the SENSOPLATE will be stuck can be curved (curved carrosery).
Please thus use the stickers thicknesses (
principles :
• First stick the stickers double-faced cloth on the SENSOPLATE, stick then the SENSOPLATE on
the body to define the number of stickers different thicknesses to superimpose.
• Stick the stickers double-faced cloth on 6 sites in a way proportioned over the length: that is to say
2 in the center around the passage of beam (
or to be defined according to the curve of the body) to approximately 110 mm and finally 2
still (thickness or
to the center stickers thickness 0,8 mm (
EXAMPLE 1: CURVED BODY
EXAMPLE 2 : RIGHT BODY
t h e
or
to be defined) on the external edges of the SENSOPLATE. • always Stick
).
110 mm
Sensoplate
110 mm
Sensoplate
22
) different to fill this curve while following these
thickness 0,8 mm.) then 2 on each side (thickness
110 mm
110 mm