IXIT REVERSE SENSOPLATE Manuel D'installation & D'utilisation page 18

F 1234 XY 56
H
1
= with the top of the plate
HEIGHT OF THE PLATE
Your plate is Plate height
positionned H* (cm) is
Very low 20 to 32 cm
Average 32 to 50 cm
Average 32 to 50 cm
High 50 to 85 cm
* H: Height from the ground to the base of the number plate
** A : Angle (approximate) of the number plate compared to the vertical of the ground
*** Ideal position: It is about the position recommended according to data's H & A. Operation of the
SENSOPLATE may be faded if this position is not respected.
SIGNIFICANT REMARK :
• Normally, the number plate does not have to be withdrawn for the installation of the SENSOPLATE.
If for example, the ideal position is with the top of the plate whereas there does not exist enough
of place to position the SENSOPLATE, it will then be necessary to withdraw the plate (to unrivet)
then the refixer a little low in order to correctly position the SENSOPLATE with the top of the plate.
• Before fixing the SENSOPLATE definivelyt, we advise you to connect the system and to make
a test to check that selected positioning is the good. Fixing will be thus detailed after the connection
of the system.
9°
1
2
2
= below the plate
ANGLE OF THE PLATE
Plate
angle is
right or tilted Sup. than 0°
rather right
tilted Sup. than 8°
rather right
18
+9°
-9°
3
= angle with +9°
SENSOPLATE POSITION
Angle A** Ideal
is position ***
1
2
0° to 8°
2
1
0° to 8°
A
3
4
H
4
= angle with -9°
Sensors'
fields
4
4
3
3