Wiring Diagram - IXIT REVERSE SENSOPLATE Manuel D'installation & D'utilisation

4. WIRING
DIAGRAMM
6 pins
connector
RED WIRE
BLACK WIRE Connect to a stud of mass of origin of the vehicle.
Pass 6 wires 1 by 1 through the hole drllled above or below the number plate. Insert then each one of these wires in
the 6 pins connector provided in each respective color. A click should ensure the right connection of the wire in the
connector. For example, a RED point on a BLACK background (sticker on the connector) means that you have to insert
the BLACK wire of the RED tube in the connector pin.
FACE 1
To
Sensoplate
FACE 2
To
Sensoplate
Main unit
Connect thanks to the red thimble provided on the wire of origin of the reversing light. When
reverse gear is passed, this wire receives + 12 V, system SENSOPLATE will then be activated
simultaneously (approximately 1 sec. later). The location of the wire of origin of the reversing
light is done thanks to multimeter or a current testing screwdriver. On the light unit integrating
the reversing light, prick wire going directly to the reversing light. When the reverse gear is
passed (lit reversing light), the wire must provide information + 12 V. When the reverse gear
is not passed, this wire provides 0 V.
20
To
main unit
To
main unit
Display
Buzzer LED
RED wire
+12V. reversing
light
BLACK wire
Ground