Before Installation - IXIT REVERSE SENSOPLATE Manuel D'installation & D'utilisation

1. BEFORE INSTALLATION

We thank you to follow these instructions before installing any REVERSE electric system on your vehicle
:
• The system works under a DC voltage of 12 volts (12V DC). Be sure of the polarity of each wire
before connection.
• Check before installation if all the electric devices of the car are working correctly (ignition, starting,
lights, indicators, central door locking, reverse light, brake light, ...). After installation, please check
again these devices.
• Connect the wires by welding (splice & soldered joint on the wire), do not use spades for quick
but unsecure connection. False contacts & short circuits can damage car electronic original
equipment.
• When you connect the main unit to the ground of the car, be sure that this ground is stable
and safe.
• Take care that all the wires hidden cannot be cut by opening a trunk or a door.
• Take care to hide as much as possible all the units and modules of the systems. The wires should
not be visible.
• Use a digital multimeter to check the polarity of all the wires (even if you have the car electric
diagram information).
• Do not remove the battery lead connection if the car radio is equipped with security code (the car
owner may not know this code) and even if the car is equipped of airbags.
• Remove the door dome light fuse to avoid to empty the battery (door opened).
The REVERSE SENSOPLATE system can be installed on multiplexed cars.
The only required electric information are :
• +12V. of reverse light
• Ground
All these information are on wires with regular information on (+ or - polarity wires). On these wires, there
are no coded information (multiplexed BUSCAN, VAN or other coded signal). You should never cut or
even touch a multiplexed wire.
IN ALL CASE, WE ADVISE YOU TO AVOID CUTTING AN ORIGINAL WIRE OF THE VEHICLE. YOU
SHOULD ONLY USE THE POSITIVE OR NEGATIVE INFORMATION OF THIS WIRE (CONNECT ON
IT) TO FEED THE REVERSE SYSTEM.
The REVERSE systems are compatible with all cars of the European market and their installation
cannot cancel or modify the guarantee conditions of the car.
MULTIPLEXED (BUSCAN) VEHICLES
16
22