Sony CDU701 Guide De L'utilisateur page 46

Reassembling the Computer
46
Installing the Drive Unit into the Computer
1
Reinstall the floppy disk drive in the top drive bay.
Reinstall the floppy disk drive.
2
Reconnect the interface cables to the floppy disk drive.
3
Fasten the screws and front brackets as they were before.
4
Tuck the cables behind the drives so that they do not protrude
above the power supply module.
5
After checking the following points, slide the computer's cover
on and fasten the cover mounting screws at the back of the
computer.
• Are the connections between the drive and computer correct?
• Are the jumpers set to the appropriate positions?
6
Remount the rear plastic panel and refer back to the proper
installation section if you answered "no" to either of the
questions above.
Tuck the cables.
Power supply