hestan KRP Serie Mode D'emploi page 17

GETTING TO KNOW YOUR REFRIGERATOR
ADJUSTING THE VARIOUS TEMPERATURE SETTINGS
Each model has been carefully tested before leaving the factory and is adjusted in such a
way to ensure high performance and low consumption. Usually, it is not necessary to modify
the settings. Nevertheless, according to special needs, it is possible to modify the set
Nevertheless, according to special needs, it is possible to modify the set temperatures as
follows:
Refrigeration From +1°C to +7°C (from 34°F to 46°F), the recommended preset
temperature is +4°C (39°F).
Compartment
To adjust the temperature use the Up/Down buttons
these buttons the newly set temperature will appear in the display. To
modify this temperature, use the buttons until reaching the desired tem
perature.
Freezer From -13°C to -23°C (from 9°F to -11°F), the recommended temperature
Compartment is preset at -18° (-1°F).
To adjust the temperature use the Up/Down buttons . Upon touching
(Fresh Zone)
these buttons the newly set temperature will appear in the display. To
modify this temperature, use the buttons until reaching the desired
temperature.
In case the compartment is used as refrigerator or Fresh Zone compartment
(Fresh Zone function) the recommended and preset temperatures will
correspond to those indicated for the respective compartments.
The temperature shown can vary slightly in
respect to the set temperature following frequent
openings of the doors or insertion of room
temperature foods or large quantities of foods.
6 to 12 hours are necessary to reach the selected
temperature.
ACTIVATING THE ICE MAKER
The Ice Maker button
activation of the automatic icemaker.
The button is illuminated when the icemaker is functioning.
A prewash of the water circuit should be performed before activating
the Ice Maker for the rst time. To do this touch at the same time
buttons Enter
After a few minutes the Ice Maker can be activated.
Do not activate the Ice Maker until the
water line is properly connected.
For freezer models
DISPLAY INFORMATION AND MALFUNCTION MESSAGES
An integrated control system provides information through light signals or
text messages visualized on the display.
The information signal is always visualized with a xed text message, while
a malfunction signal is visualized with blinking text. The sound signal that
accompanies some malfunction signals can be deactivated by pressing
the Alarm button
The list of malfunction signals is located at the back of this manual.
located on the main control panel permits
and Ice Maker
.
on the main control panel.
(continued)
. Upon touching
-
©2018 Hestan Commercial Corporation
EN
15