Install The Battery Pack; Remove The Battery Pack; Operation; Start The Machine - GreenWorks POWERALL 24V Manuel D'opérateur

EN
8.5

INSTALL THE BATTERY PACK

• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
16
8.6

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (1).
2. Remove the battery pack from the machine.
9

OPERATION

Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

START THE MACHINE

1. Push the lock-out switch (4) and pull the trigger (3).
WARNING
IMPORTANT
WARNING
English
2. Push the speed switch (5) to the desired operating speed.
Push the speed switch to position 1 for low speed or
position 2 for high speed.
9.2

STOP THE MACHINE

1. Release the trigger to stop the machine.
9.3 ADJUST THE LENGTH OF THE
CUTTING LINE
While you operate the machine, the cutting line gets worn
shorter. You can adjust the length of the cutting line.
1. While the trimmer is running, bump the trimmer head
against the ground.
2. Line is automatically released and the cut-off blade cuts
the excess length.
9.4 ADJUST THE CUTTING
DIAMETER
The machine is set at a 13 in. (330mm) cutting diameter.
You can adjust to a 15 in. (381mm) cutting diameter.
Set the cutting diameter to 13 in. (330mm) for greater
runtime and 15 in. (381mm)for a larger cutting area.
1. Remove the battery pack.
8
4
5
NOTE
3