Attach The Auxiliary Handle; Install The Battery Pack; Remove The Battery Pack - GreenWorks TORQDRIVE STG308 Manuel De L'utilisateur

EN
2
2. Align the release button (2) with the positioning hole (1)
on the upper shaft (3) and slide the two shafts together
until the button locks into the positioning hole.
3. Repeat above procedure to connect lower shaft to middle
shaft.
8.5 ATTACH THE AUXILIARY
HANDLE
1. Remove the knob from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable position.
1
5
English
4. Put the bolt through the holes.
5. Tighten the auxiliary handle with the knob.
8.6

INSTALL THE BATTERY PACK

3
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
4
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.7

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (1).
2. Remove the battery pack from the machine.
8
WARNING