Using The Tool; Adjusting Fastener Depth - Haussmann PNT210-B Manuel De L'utilisateur

OPERATING INSTRUCTIONS
2. Pull feeder shoe all the way to the rear, until it latches.
3. Line up a strip of nails with points down and drop into the magazine.
4. Slide the nails forward in the magazine. The magazine will hold 2 strips of 30 nails at
21 degrees.
5. Push the lock forward and allow the feeder shoe to slide forward against nails.

USING THE TOOL

Complete all the steps in PREPARING THE TOOL before using. This tool drives nails
in sequential fire mode:
1. Put the contact tip of the tool on the working surface.
2. Lightly push the tool toward the working surface until the safety bracket is
depressed.
3.
most accurate fastener placement.
CAUTION:


 Keep the tool pointed in a safe direction at all times.
 Never attempt to drive a fastener into material that is too hard, at too steep an
angle, or near the edge of the work piece. The fastener can ricochet causing
personal injury.
 Clean and inspect the tool daily.
 Carefully check for proper operation of the trigger and safety.
 Do not use the tool unless both the trigger and the safety mechanism are
functional, or if the tool is leaking air or needs any other repair.

ADJUSTING FASTENER DEPTH

The depth to which a fastener is driven is controlled by the depth adjustment.
The depth drive is adjusted to the maximum setting by the factory.
1. Fire a fastener into a scrap work piece to check depth.
2. If the fastener is driven too deep, rotate the knob counter-clockwise.
3. If a greater depth is desired, rotate the knob clockwise.
4. Fire another fastener in a scrap work piece and check the depth.
5. REPEAT AS NECESSARY UNTIL DESIRED DEPTH IS ACHIEVED. The
amount of air pressure required will vary depending on the size of the setting.
CAUTION: Disconnect tool from the air supply before removing or installing the
contact tip.
20
PNT210-B
!
!