Using The Tool - Haussmann HFNC1590 Manuel D'utilisation

3. Open cover plate (K, fig.5)
4. Open the lower magazine (J, fig.2).
5. Place a coil of nails in the lower magazine.
6. Rotate magzine height adjustment knob (G, fig.6) to adjust the lower magazine
according to the nails' length. The highest position is used for 2" (50mm) nails
while the lowest position is used for 3-9/16" (90mm) nails. For all nails between
minimum and maximum, adjust lower magzine accordingly.
7. Close lower magazine.
8. Draw the nails out and position the second nail on to the feed hook (M, fig.5).
9. Close cover-plate and latch (L, fig.4).
10. Rotate the directional exhaust deflector (C, fig.2), so that the exhaust air blast
will be directed away from the operator.

USING THE TOOL

Complete all steps as indicated in PREPARING THE TOOL and LOADING
FASTENERS before using. This tool can be fired in two different ways:
SEQUENTIAL FIRE
1. Turn the trigger mode selector (D, fig.2) so the tail of selector is up (fig.7)
2. Put the contact tip (A, fig.2) of the tool on the working surface.
3. Lightly push the tool toward the working surface until the safety bracket is
depressed.
4. Press the trigger (E, fig.2) to drive the fasteners. This "trigger fire" method
provides the most accurate fastener placement.
BUMP FIRE
1. Turn the trigger mode selector (D, fig.2) so the tail of selector is down.(fig.7)
2. Hold the contact tip (A, fig.2) off the surface
3. Press the trigger.
22
OPERATING PROCEDURES
fig. 5
fig. 6
fig. 7