Fastener Depth - Haussmann HFNC1590 Manuel D'utilisation

OPERATING PROCEDURES
!
!
!
4. Keeping the trigger pressed, push the contact tip (A, fig.2) of the safety bracket
against the working surface. Once the bracket is pushed back enough, the nail
will fire.
CAUTION:
z Disconnect tool from air supply before performing maintenance, clearing a
jammed fastener, leaving working area, moving tool to another location or
handing the tool to another person.
z Clean and inspect tool daily. Carefully check for proper operation of trigger
and safety mechanism.
z Do not use the tool unless both the trigger and the safety mechanism are
functional.
z Do not use the tool if its leaking air or needs any other repair.

FASTENER DEPTH

Driving depth can be adjusted by rotating the depth adjustment knob (B, fig.2 & 8).
1. Test fire a fastener into a scrap work piece and check depth.
2. If the nail is driven too deep, rotate the knob clockwise (when tool is upside-
down) to move the safety bracket downward.
3. If a greater depth is desired, rotate the knob counter clockwise to adjust the
safety bracket upward.
4. Test fire another fastener in a scrap work piece and check the depth.
5. REPEAT AS NECESSARY UNTIL DESIRED DEPTH IS ACHIEVED. The
amount of air pressure required will vary depending on the size of the setting.
6. Determine the lowest setting that will consistently perform the job at hand.
Excessive air pressure may cause premature wear and/or damage to the tool.
fig. 8
CLEARING A JAMMED FASTENER
CAUTION: Disconnect tool from air supply.
1. Open latch.
2. Rotate lower magazine.
3. Remove the nails from the magazine.
4. Use a slender, soft steel rod to drive the drive blade to its uppermost position.
5. Use a pair of needle nose pliers to remove the jammed fastener.
6. Follow instructions in PREPARING THE TOOL BEFORE DRIVING to reload
fasteners.
CAUTION:
z Keep the tool pointed away from yourself and others at all times.
z Always connect the tool to air supply before loading fasteners.
z Do not load fasteners with safety or trigger depressed.
z Always wear approved safety glasses and hearing protection when preparing
or operating this tool.
z Never use a tool that leaks air or needs repair.
23