Functional Description; Operating Procedures; Air Source - Haussmann HFNC1590 Manuel D'utilisation

FUNCTIONAL DESCRIPTION

Figure 2 names the major components.
A. Contact tip
B. Depth adjustment knob
C. 360 degree re-directable exhaust port
D. Trigger mode selector
E. Trigger
F. Male quick-connect fitting
G. Magazine height adjustment knob
H. Magazine height indicator
I. Magazine height scale
J. Lower magazine
K. Feed cover plate
L. Cover plate latch

OPERATING PROCEDURES

SET UP
Your HAUSSMANN Framing Coil Nailer is fully assembled when you receive it.
See the recommended air system setup (fig.3) below. Be sure that the couplers are
set up so that the air hose is depressurized when adding or removing components
from the system.
Nailer
Quick-connector

AIR SOURCE

z The 5726023 framing nailer is designed to operate on clean, dry, compressed
air, regulated at 70 - 120 PSI. The preferred system (fig.3) would include a
filter, a pressure regulator, and an automatic oiler located as close to the tool as
possible; within 15' (5 m) is ideal. Do not use bottled air or gases.
z Determine if it is necessary to lubricate. All compressed air contains moisture
and other contaminants that can harm the internal components of the tool. An
air line filter will remove most of these and significantly prolong the life of the
tool. If you are using an in-line automatic oiler, check and add oil if necessary.
If an in-line oiler is not available, place 5 or 6 drops of oil into the tool's quick-
20
Air Hose Regulator
Oiler
Air Supply
Filter
fig.2
fig. 3