Iwata WORKSHOP IWC28S Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

AVERTISSEMENT
Improper care could lead to the air tank bursting or
exploding.
Drain air tank daily or after each use to prevent moisture
buildup in the air tank.
Rust can weaken the air tank and cause leaks or
bursting. If rust is detected, replace tank immediately.
Do not try to repair the air tank by welding, drilling or
modifying it in any other way. These modifications can
weaken the air tank and cause a hazardous condition.
If air tank develops a leak, replace the air tank
immediately. Never repair, weld or make modifications
to the air tank or its attachments.
Never make adjustments to the factory-set pressures.
Never exceed manufacturer's maximum-allowable
pressure rating attachments.
Because of extreme heat, do not use plastic pipe or
lead tin solder joints for a discharge line.
GROUNDED
OUTLET
GROUNDING
PIN
Customer Support 503-253-7308 M-F, 8am-4:30pm PST | iwata.support@iwata-medea.com | www.iwata-airbrush.com/blog/contact-us
(A)
www.iwata-airbrush.com
AVERTISSEMENT
Use caution to minimize risk of fire or explosion.
It is normal for the air compressor motor and pressure
switch to produce sparks while operating. If sparks come
in contact with vapors from gasoline or solvents, they
may ignite and cause a fire or explosion.
Abrasive tools such as grinders, drills and other tools
are capable of making sparks that can ignite flammable
materials.
Always operate the air compressor a safe distance away
from flammable items. Use in well-ventilated areas.
Never exceed the maximum rated pressure.
Use caution when using extension cords.
ATTENTION
Use an extension cord which is no more than 25' (7.6 m)
long and at least 14 gauge.
Using an excessively long or thin-wired extension cord
will cause severe damage to the motor.
Use only a 3-wire extension cord that has a 3-blade
grounding plug.
An undersized cord results in a drop in the line voltage
and loss of power and overheating.
When in doubt, use a heavier gauge. The smaller the
gauge the more current the cord can carry.
THIS EQUIPMENT INCORPORATES PARTS, SUCH AS
ATTENTION
SNAP SWITCHES, RECEPTACLES AND THE LIKE THAT
TEND TO PRODUCE ARCS OR SPARKS, THERE, WHEN
LOCATED IN A GARAGE, IT SHOULD BE IN A ROOM
OR ENCLOSURE PROVIDED FOR THE PURPOSE, OR
SHOULD BE 18 IN (45.7 CM) OR MORE ABOVE THE
FLOOR.
Quiet Oil-Free Air Compressor
5

Publicité

Chapitres

Table des Matières
loading

Table des Matières