Safety Warnings; Installation Warnings; Maintenance Warnings; Warnings For The User - Palazzetti Ecofire Généralités - Avertissements - Installation - Entretien

2 SAFETY WARNINGS

2.1 INSTALLATION WARNINGS

C
manual.
The stove assembly and dismantling instructions
are reserved exclusively for specialist technicians.
Users should always contact our service centre
technicians. Before having work performed by
other technical personnel verify their effective
technical competence.
Responsibility for work carried out in the place
where the stove is installed lies with the user;
the user is also responsible for making sure the
installation checks are completed.
The user must abide by all local, national and
European safety requirements.
suitable load-bearing capacity.
Make sure that the flue and air intake duct
arrangements correspond to the type of installation.
Do not make any electrical connections using
temporary or uninsulated cables.
Make sure the electrical system is earthed
correctly.
Before starting to assemble or dismantle the stove,
the installer must heed the safety precautions
A) do not work in adverse conditions;
B)
and make sure that personal protective
equipment is in perfect working order;
C) always wear safety gloves;
D) always wear safety shoes;
E) always use electrically insulated tools;
F) make sure that the area being used for assembly
and dismantling is clear of any obstacles.

2.2 MAINTENANCE WARNINGS

manual.
• Use always personal protective equipment and
other means of protection.
• Before starting any maintenance work make sure
that the stove, if it had been operating, has cooled
down.
• If even just one of the safety devices is not
calibrated or not working, the stove must be
considered out-of-service.
• Disconnect power before working on electrical or
electronic parts and connectors.
INTRODUCTION

2.3 WARNINGS FOR THE USER

Prepare the stove installation site in accordance
with local, national and European regulations.
• As the stove is a heating appliance it has very hot
outside surfaces. For this reason maximum care
•
•
•
•
•
•
•
•
manual.
• Follow the instructions and warnings highlighted
• These labels are safety devices, therefore they
must always be perfectly legible. If damaged or
illegible they must be replaced, contacting the
manufacturer for an original spare label.
•
shown in the corresponding chapter of this manual.
• Strictly follow the routine and special maintenance
plan.
•
"Maintenance" in this manual.
• Do not use the stove in the event of malfunctions,
suspected breakage or unusual noises.
• Do not pour or spray water onto the stove when
pot.
• Do not switch the stove off by unplugging the
power cord.
• Do not rest your weight on the open door as this
may affect stability.
• Do not use the stove in any way as a support or
anchor.
• Do not clean the stove until the structure and ash
have completely cooled down.
• Touch the door only when the stove has cooled
down.
• Perform all operations without haste, in such a
way as to ensure maximum safety.
•
off.
•
• Do not touch the painted parts during operation to
avoid damaging the paintwork.
do not touch or get too close to the glass
door to avoid getting burned;
do not perform any type of cleaning;
do not remove the ash;
do not open the glass door;
do not open the ash bin (where featured);
make sure children keep away from the
stove.
do not place any object on the stove.
19